Set up Mix 1 as a "Normal" mix (not a Curve) as follows: Next, go out to the Function Menu and get to Mixing. Select Switch B, and set the values as follows: Next, go to System Setup > Digital Switch Setup. You can use any switch you like it doesn't have to be Switch B, but that's what I'm going to refer to below. Set the Aux1 channel to "Inh" (inhibit, or no switch assigned). That lets you arbitrarily assign values to each position of a switch, so you get more flexibility in how the switch can control the settings on the aircraft.Īs an example, I'm going to set up a single switch (Switch B) so that it can control the modes in this manner:įirst, go to System Setup > Channel Assign, then click Next to get to the Channel Input Config screen. With a Gen2 transmitter, you have access to a feature called Digital Switch Setup. I don't think it's very convenient to coordinate two switches like that, so I'd like to get three of the four possible combinations onto one switch for simpler access. The Convergence offers two sets of mode settings - the flight mode (Mutli-Rotor or Airplane) and the stabilization mode (Stability or Acro). Future firmware/sound file revisions might have better sounds. I'm using a DX9 on firmware 1.09 (October 2015), so I found the best sounds I could for Switch H. The attached SPM file includes voice alerts on the timer and the switches. Switch H (Aux1 Channel) - Position 0 = Airplane Mode, Position 1 = Multirotor Mode Switch A (Gear Channel) - Position 0 = Stability Mode, Position 1 = Acro Mode With all of that done, the switches will control flight modes this way: The second screen under timer (click NEXT) lets you change all sorts of callouts/alerts that can be activated as the timer counts down. The default setting of 5 minutes seems about right for this aircraft, but I'd always suggest flying for a shorter time than the manual suggests until you have flown a couple of batteries and you can see how much charge is left in them after you fly the aircraft your way. Go to Timer and make any changes to the timer. For a much deeper discussion of D/R & Expo, see this post in my blog:ĩ. You can make that on all the time (Switch: on) or assign it to a switch so you can turn it on and off. Under D/R & Expo, you may assign the suggested 25% expo on the elevator and aileron channels. Select at the top of the menu to exit the System setup menu, and then go from the main model screen into the Function Menu (click roller).Ĩ. The software in the flight controller is designed for both of those channels to be assigned to two-position switches.ħ. Check that Gear is set for Switch A, and change Aux1 to Switch H. That takes you to the Channel Input Config screen. On the first screen that appears, Rx Port Assignments, simply go down to "NEXT" - don't change anything.Ħ. You can go into Aircraft Type and verify that it's set for Wing Normal/Tail Normal, which is the default setting.ĥ. Hint: to quickly clear the existing name out of the way, press the CLEAR button twice while the cursor is pointing at the first character in the name (probably a number).Ĥ. Next, go to Model Name and give it a name. After the model is created, go to Model Type. Go to the System Setup menu, and then go to Model Utilities. Here's how to set up a model on a Spektrum Gen 2 (DX9, DX18, DX6G2/G3, DX7G2, DX8G2) transmitter.ġ.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |